UDP Stop
Last updated
Last updated
UDP Stop stops the UDP connection, which was previously established with UDP Start.
UDP Communication in Incari is available as a plugin and is enabled as default. However, in the case that it is disabled in the Plugins Editor, it will not appear in the Project Settings and UDP Stop will not show up in the Toolbox. Please refer to the Plugins Editor to find out more information.
It is important to note that while the UDP Stop Node stops a UDP connection, it may not completely finish disconnecting from said connection when the Node is executed. This could lead to the Logic attached to its Output Pulse to not work even though there is technically nothing wrong. In order to avoid this, it is highly suggested to use the On UDP Stop Node instead. This way, the Logic will only execute once the UDP connection has definitely been disconnected from. This way, it is assured that the Logic will execute once the connection to the UDP connection has been terminated.
Again, the user must first use the UDP Stop Node to close the connection. Separately, the On UDP Stop Node can be used to execute the desired Communication Logic.
Scope: Project, Scene.
Configuration
Drop-Down
Pulse Input (►)
Pulse
A standard Input Pulse, to trigger the execution of the Node.
Pulse Output (►)
Pulse
A standard Output Pulse, to move onto the next Node along the Logic Branch, once this Node has finished its execution.
The desired UDP server, which refers back to the selections made under UDP in the .
